SuperTag / Sensormatic EAS Ink Tag Sensor Remover

You are purchasing 1 handheld sensor remover for SuperTags / Sensormatic / EAS tags.  This remover does not require electricity or internet to use.  The cord allows you to fasten it to a table if you don't want to misplace it.   This single remover will take off all tags that look like this:

There are three types of sensor removers.  If you are purchasing unprocessed pallets (meaning we have not removed the sensors for you) you will have to remove them on your own.  They are very easy to remove with the three correct tools. Learn about them in the video below:

The sensor removers we are selling are new, good quality removers.  If you prefer to buy a professional quality remover, they are around $450 each or you can purchase ours which is cheaper yet gets the job done. 

DO NOT TRY “HACKS” SHOWN ON THE INTERNET.  Not only are the internet hacks dangerous, but they are exceptionally time consuming.  The more time you spend trying to remove sensors, the slower your turnaround time.  It is always better to buy the correct tools and get the merchandise selling as fast as possible so you can reinvest in more. 

Let's discuss the awful internet advice because it is important you know why it is terrible.  First, burning tags off by melting the plastic with a flame is not only time consuming but it is also incredibly dangerous because you are melting toxic, carcinogenic plastic.  In order for plastic to melt, it has to reach 400-500F!  This level of heat can cause severe burns on your skin and, should the plastic drip, it will ruin the apparel.  

Freezing the tags then smashing them with hammers does not work because a large quantity of sensors now have “freeze proof ink”, but you won’t know if the tag has this type of ink until you smash it open and see if it sprays all over.  Additionally, it is a great way to rip a hole in the apparel. 

Dremels and similar cutting tools only work if there is space between the apparel and the sensor, which is not common.  Usually the apparel is flush against the sensor so there is no room for a cutting tool.  

Wire Cutters - standard cutters are not strong enough, you would need bolt cutters, which will not fit in the small space.  

The only realistic way to remove the sensors quickly and not ruin your merchandise is with the three proper tools.  If you absolutely refuse to purchase the three tools, you can get some tags off with a mini-pry bar.  It requires a great deal of hand-muscle strength (and time).  This method will not work on tags with ink in them.